Telephone base installation
This quick start guide provides you with basic instructions only.
For more complete instructions, refer to your Abridged user’s
manual provided in the package, or see the online Complete
user’s manual at www.telephones.att.com/manuals.
Battery installation
Install the battery as shown below. Charge your handset(s) before initial use.
The battery is fully charged after ten hours of continuous charging.
Quick start guide
CL82113/CL82213/CL82263/CL82313/CL82363/
CL82413/CL82463
Use only the supplied rechargeable battery or replacement battery (model BT183342).
Caution: Use only the power adapter(s) provided with this product. To obtain a replacement,
visit our website at www.telephones.att.com or call 1 (800) 222-3111.
In Canada, dial 1 (866) 288-4268.
Quick reference guide - handset
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up as indicated.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until it
clicks into place.
Step 3
Charge the handset by placing it face forward in
the telephone base or charger. The CHARGE light
on the handset is on during charging.
PUSH TO TALK
Press to initiate a one-to-one or
one-to-group broadcast.
Press and hold to broadcast to a group of
system handsets.
•
•
Quick reference guide - telephone base
Raise the
antenna.
Route the power
adapter cord
through this slot.
Plug the large end
of the telephone
base power
adapter into a
power outlet not
controlled by a
wall switch.
Plug one end of
the telephone
line cord into a
telephone jack
or a DSL filter.
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required.
Route the
telephone line cord
through this slot.
CHARGE light
CHARGE light
On when the handset is
charging in the telephone base
or charger.
REDIAL/PAUSE
Press repeatedly to view the
last ten numbers dialed.
While entering numbers,
press and hold to insert a
dialing pause.
•
•
qCID/VOLUME
Press qCID to show caller
ID log when the handset is
not in use.
Press to scroll down while
in menus.
Press to decrease the
listening volume when on
a call.
•
•
•
PHONE/FLASH
Press to make or answer a
call.
•
1
Press and hold to set or dial
your voicemail number.
•
TONE /a>A
Press to switch to tone
dialing temporarily during
a call if you have pulse
service.
While entering names, press
to change the next letter to
upper or lower case.
•
•
/SPEAKERSPEAKER
Press to make or answer a
call using the speakerphone.
•
pDIR/VOLUME
Press pDIR to show
directory entries when the
handset is not in use.
Press to scroll up while in
menus.
Press to increase the
listening volume when on
a call.
•
•
•
MENU/SELECT
When the handset is not
in use, press to show the
menu.
While in the menu, press to
select an item or save an
entry or setting.
•
•
OFF/CANCEL
During a call, press to hang
up.
While in a menu, press to
cancel an operation, back
up to the previous menu,
or exit the menu display, or
press and hold this button
to exit to idle mode.
•
•
QUIET# (pound key)
Press and hold to enter the
QUIET mode setting screen,
or to deactivate QUIET
mode.
•
MUTE/DELETE
During a call, press to mute
the microphone.
Press to delete digit or
character.
•
•
EQ
During an outside call,
intercom call, message or
announcement playback, press
to change the audio quality to
best suit your hearing.
Charger installation
Plug the power adapter
into a power outlet not
controlled by a wall
switch.
Handset
side view
Plug the other end
of the telephone
line cord into the
telephone jack on the
back of the telephone
base.
Plug the small end of the telephone base
power adapter into the power adapter
jack on the back of the telephone base.
IN USE indicator
On when the handset is in use,
or when the answering system is
answering an incoming call.
Flashes when another
telephone is in use on the
same line.
•
•
/SKIP
Press to skip a message.
/REPEAT
Press to repeat a
message.
Press twice to
play the previous
message.
•
•
/ANSWER ON/OFF
Press to turn the built-in
answering system on or off.
Message counter
Shows the number of messages or other answering
system information.
/HANDSET LOCATOR
While the phone is idle,
press to page all handsets.
/PLAY/STOP
Press to start or stop message
playback.
qVOL
-
and pVOL
+
During message playback,
press to adjust the listening
volume.
While in idle mode, press to
adjust the base ringer volume.
•
•
X/DELETE
Press to delete the message
currently playing.
Press twice to delete all old
messages when the phone is
not in use.
•
•
(34 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals